Sorry if this is not alright.
I decided I wanted to enter my first build and decided as I'm still an amateur to do a rally car with loads of decals
and I went with This Airfix Fiesta. I was planning on doing a diorama rally scene but I think i'll leave it this time. I want to start on my Tamiya Bike, again for this buildThis is a nice shoot of the kit, decals, instruction, and all that jazz.
Spure shot.... the spures where really nice, ok amount of detail, very little flash etc.
The shell... this was really nice great detail, no flash, no ejection pin marks. Very impressed.
A couple of the page from the instruction sheet. Nice simple build.
The decals looked great as well. This was looking like a great kit, considering it was an Airfix starter kit.
Lets get on with the build. The build was going well but there were a couple of issues. Number one being the fact that one of the wheel arches was about a mile out. a bit of milliput and I'll sort that right out.
The body also had a crack. Bit of extra thin to fix that.
and then I lost one of the roof anteena's (the rug monster got it) so had to fill in the hole this time with Perfect Plastic putty.
oh and I almost forgot about the fact that I stuck on the spoiler before the lights which caused proper issue's near the end of the build with getting them in place. I had to trim the spoiler abit.
So quite a few issues.
Body ready for priming.
again I messed up I should have left the antenna's off until the end because I ended up breaking them during the build.
